電動平車電池的保養方法

　　電動平車電池的保養方法

　　1、避免充電時插頭發熱

　　發熱時刻過長會導致充電插頭短路，充電器輸出插頭松動、接觸面氧化等現象都會導致充電插頭發熱。直接損害充電器，帶來不要的丟失。所以電動平車電池呈現上述狀況時，及時清除氧化物或更換接插件。

　　2、精確把握充電時刻

　　應根據實際狀況精確把握充電時刻，運用過程中。參考平常運用頻率及行進路程狀況，也要留意提供的容量大小闡明，以及配套充電器的性能、充電電流的大小等參數把握充電頻次。一般狀況蓄電池都在夜間進行充電，平均充電時刻在8小時左右。若是淺放電電池很快就會充溢，持續充電就會呈現過充現象，導致電池失水、發熱，降低電池壽命。所以，蓄電池以放電深度為60%-70%時充一次電佳，實際運用時可折算成騎行路程，根據實際狀況進行要充電，避免傷害性充電。

　　3、避免瞬間大電流放電

　　請用腳蹬助力，電動平車在起步、載人、上坡時。盡量避免瞬間大電流放電。大電流放電簡單導致發生硫酸鉛結晶，從而損害電池極板的物理性能。

　　4、禁止處于虧電狀況

　　蓄電池在存放時禁止處于虧電狀況，很簡單呈現硫酸鹽化。虧電狀況是指電池運用后沒有及時充電。虧電狀況存放電池。硫酸鉛結晶物附著在極板上，堵塞了電離子通道，造成充電缺少，電池容量下降。虧電狀況擱置時刻越長，電池損壞越重。因而，電動平車電池擱置不用時，應該每月充電一次，這樣能較好地堅持電池健康狀況。

　　5、定期檢驗避免曝曬

　　假如電動平車的續行路程在短時刻內忽然下降十幾公里，運用過程中。則很有可能是電池組中罕見一塊電池呈現斷格、極板軟化、極板活性物質掉落等短路現象。此刻，應及時到專業電池組織進行檢查、配組。這樣能相對延伸電池組的壽命，洪流平地節省開支。電動車禁止在陽光下曝曬。溫度過高的環境會使蓄電池內部壓力添加而使電池限壓閥自愿主動開啟，結果便是添加電池的失水量，而電池過度失水必定引發電池活性下降，加快極板軟化，充電時殼體發熱，殼體起鼓、變形等致命損害。

• 上一篇：電動平車的操作及注意事項
• 下一篇：電動平車起步時留意事項